The Blue Smart IP67 Waterproof Charger is the new professional battery charger with built-in Bluetooth. The Blue Smart IP67 Waterproof Charger can be used on devices from your workshop and motor vehicles, such as cars (classic), motorcycles, boats and motorhomes.
With Bluetooth Smart
The Blue Smart IP67 charger is the wireless solution to control the voltage and current, to change the settings and to update the charger when there are new functions available. With Bluetooth, the functionality of the IP67 charger is improved and is similar to that of our IP22 and IP65 chargers.
Completely encapsulated: Water resistant, blows and protected against ignition
Water, oil or dirt will not damage the Blue Smart IP67 charger. The housing is made of cast aluminum and electronics is molded in resin.
The greatest efficiency of history
€189.99
(tax incl.)
Reference:
522302120265
Brand:
Love0
Add to compare0
Add to wishlist
Establishing a new standard in the industry: With an efficiency of 92% or higher, these chargers waste three to four times less heat. And once the battery is fully charged, the energy consumption is reduced to less than a watt, between five and ten times better than the industry standard.
Adaptive 5-stage charging algorithm: Bulk - Absorption - Reconditioning - Flotation - Storage
The Blue Smart Charger charger has an "adaptive" management of the microprocessor controlled battery. The "Adaptive" function will automatically optimize the loading process depending on the use of the battery.
- Storage mode: Less maintenance and aging when the battery is not in use
The storage mode is activated when the battery has not been downloaded for 24 hours. In storage mode, the flotation voltage is reduced to 2.2 V / cell (13.2 V for a 12 V battery) to minimize the gasy and corrosion of positive plates. Once a week, the tension is reread again at the absorption level to "match" the battery. This function avoids the stratification of the electrolyte and sulfation, one of the main causes of premature batteries failures.
- Also load lithium-ion batteries
Lithium-ion batteries are charged with a simple absorption and flotation algorithm.
- Fully downloaded battery recovery function
It will start the load even if the battery has been downloaded to zero volts. A lithium-ion battery is reconnected fully discharged with the internal disconnect function.
- Protection against overheating
It can be used in a hot environment, such as a machine room. The output current will be reduced as the temperature increases up to 60 ° C, but the charger will not fail.
- Two state indication LEDs
Yellow LED: massive load (fast flashing), absorption (slow flashing), flotation (solid), storage (off) green led: on
Brand: Victron Energy
Intensity: 12 a
Entrance voltage: 230 V
Exit voltage: 24 V
Number of outputs: 1
Maximum efficiency (%): 93
BluetoothYes
ON / OFF remote: No
Input connections CA / CC: 1.5 meter cable with EEC plug 7/7
Connections to the battery: Red and black cables of 1.5 meters
Dimensions and weight
Stop: 8.5
Width: 21.1
Long: 6.5
Weight: 2.4