Anchor layer professional floating boat 21 meters

This cape anchor for use on larger boats or for extreme conditions. It uses a 200D fabric covered with 0.45mm PVC. In addition, 40mm straps and a 6mm stainless steel ring contribute to its resistance. Available with a yellow dunnage bag, in yellow and in three sizes.

Made of strong PVC, covered with continuous inner straps to be even stronger.

Use:
A cape anchor is part of the essential equipment on board. It is used to slow down a boat or life raft in extreme sea and wind conditions. It can also be used to give stability and direction during a drift. Apart from these uses, it is useful for boats on the high seas or in waters that are too deep to anchor, in this case it is used when fishing by churning, for example.

Instructions for use:
Made of resistant PVC with opening on both sides, it includes handles at both ends. Using the handles in the largest opening (C) a rope connected to the boat (B) is fixed, the rope must have at least 5 times the length of the boat (A). The larger the layer anchor, the more efficient it will be.
To raise the cape anchor aboard use a second rope attached to the handle in the smaller opening (D).
To make it visible that you are using a cape anchor and prevent the line from being run over by other boats you can attach a floating buoy to the line used to remove the anchor (E).

Attention: This is a general guide and there may be variations due to various factors such as the shape and weight of your boat. In addition, the type of use for which your layer anchor is intended will define the appropriate size.